How to Camp Out Part 8

Guy-lines made of six-thread manilla rope are put in at the four corners of the eaves, and at every seam along that tabling, making five upon each side. Work an eyelet, or put a grommet, in the doubled cloth of the seam; knot the end of the guy-line to prevent its pulling through: tying the rope makes too bungling a job, and splicing it is too much work.

The six guy-lines in the body of the tent should be about nine feet long, the four corner ones about a foot longer. The fiddles[19] should be made of some firm wood: pine and spruce will not last long enough to pay for the trouble of making them.

The poles should be nine feet and four or five inches long. If they are too long at first, sink the ends in the ground, and do not cut them off until the tent has stretched all that it will.

In permanent camp a "fly" over the tent is almost indispensable for protection from the heat and pelting rains. It should be as long as the roof of the tent, and project at least a foot beyond the eaves. The guy-lines should be a foot or more longer than those of the tent, so that the pins for the fly may be driven some distance outside those of the tent, and thus lift the fly well off the roof.

CLOTH FOR TENTS.

For convenience we have supposed all of the tents to be made of heavy drilling. Many tent-makers consider this material sufficiently strong, and some even use it to make tents larger than the United States army wall-tent. My own experience leads me to recommend for a wall-tent a heavier cloth, known to the trade as "eight-ounce Raven's" duck,[20]

because drilling becomes so thin after it has been used two or three seasons that a high wind is apt to tear it.

The cost of the cloth is about the same as the value of the labor of making the tent; but the difference between the cost of drilling and eight-ounce duck for a wall-tent of four breadths with a fly is only three to four dollars, and the duck tent will last nearly twice as long as the one of drilling. For these reasons it seems best not to put your labor into the inferior cloth.

Before you use the tent, or expose to the weather any thing made of cotton cloth, you should wash it thoroughly in strong soap-suds, and then soak it in strong brine; this takes the sizing and oil out of the cloth, and if repeated from year to year will prevent mildew, which soon spoils the cloth. There are mixtures that are said to be better still, but a tent-maker a.s.sures me that the yearly was.h.i.+ng is better than any thing applied only once. Some fishermen preserve their sails by soaking them in a solution of lime and water considerably thinner than whitewash. Others soak them in a tanner's vat; but the leather-like color imparted is not pleasing to the eye. Weak lime-water they say does not injure cotton; but it ruins rope and leather, and some complain that it rots the thread.

It will save strain upon any tent, to stay it in windy weather with ropes running from the iron pins of the upright poles (which should project through the ridgepole and top of the tent) to the ground in front and rear of the tent. A still better way is to run four ropes from the top--two from each pole-pin--down to the ground near the tent-pins of the four corner guy-lines. The two stays from the rear pole should run toward the front of the tent; and the two front stays toward the rear, crossing the other two. The tent is then stayed against a wind from any quarter, and the stays and guy-lines are all together on the sides of the tent.

Loosen the stays and guy-lines a little at night or when rain is approaching, so as to prevent them from straining the tent by shrinking.

Around the bottom of any tent you should dig a small trench to catch and convey away the water when it rains; and I caution you against the error which even old campers sometimes make,--do not try to have the water run up hill.

HOW TO PITCH A WALL-TENT QUICKLY.

After you have once pitched the tent, and have put the poles and pins in their exact places, note the distance from one of the upright poles to the pin holding one of the nearest corner guy-lines, and then mark one of the poles in such a way that you can tell by it what that distance is. When you next wish to pitch the tent, drive two small pins in the ground where the two upright poles are to rest,--the ridgepole will tell you how far apart they must be,--then, by measuring with your marked pole, you can drive the four pins for the corner guys in their proper places.

Next spread the tent on the ground, and put the ridgepole in its place in the top of the tent, and the two upright poles in their places. Then raise the tent. It will take two persons, or, if the tent is large, four or more, having first moved it bodily, to bring the feet of the upright poles to touch the two small pins that you drove at the beginning. You can now catch and tighten the corner guy-lines on the four pins previously driven. In driving the other pins, it looks well to have them on a line, if possible; also try to have the wall of the tent set square: to do this you must tie the door just right before you tighten a guy-line.

You will find this way of pitching a tent convenient when a wind is blowing, or when your a.s.sistant is not a strong person. If the wind is very high, spread your tent to windward, and catch the windward guy-lines before raising the tent. You will thus avoid having it blown over.

TENT-POLES.

As tent-poles are not expensive, you may find it convenient to have two sets for each tent; one stout set for common use, and a lighter set to take when transportation is limited. Sound spruce, free from large knots and tolerably straight-grained, makes good poles; pine answers as well, but is more expensive.

The upright poles of a stout set for a wall-tent of the United States Army pattern should be round or eight-sided, and about two inches in diameter.[21] If you prefer to have them square, round off the edges, or they will be badly bruised upon handling. Drive a stout iron pin[22]

seven or eight inches long into the centre of the top until it projects only about three and a half or four inches, or enough to go through the ridgepole and an inch beyond. It will be necessary to bore a hole in the pole before driving in the pin, to prevent splitting. A ferrule is also serviceable on this end of the pole.

The ridgepole should be well rounded on the edges, and be about two and a half inches wide and two inches thick. If made of stuff thinner than an inch and a half, it should be wider in the middle than above stated, or the pole will sag. Bore the holes to receive the pins of the uprights with an auger a size larger than the pins, so that they may go in and out easily: these holes should be an inch and a half from the ends.

Ferrules or broad bands are desirable on the ends of the ridgepole; but if you cannot afford these you may perhaps be able to put a rivet or two through the pole between the ends and the holes, or, if not rivets, then screws, which are better than nothing to prevent the pin of the upright from splitting the ridgepole.

TENT-PINS.

Tent-pins should be made of sound hard wood; old wheel-spokes are excellent. Make them pointed at the bottom, so that they will drive easily; and notch them about two inches from the top, so that they will hold the rope. Cut away the wood from just above the notch towards the back of the head; this will prevent the notch of the pin from splitting off when it is driven. It is well to have pins differ in length and size: those for the corners and the stays should be the largest, say fifteen to eighteen inches long; and those for the wall and door may be eight or ten inches. But pins of these sizes are apt to pull out in a heavy storm; and so when you are to camp in one spot for some time, or when you see a storm brewing, it is well to make pins very stout, and two feet or more long, for the stays and four corner guy-lines, out of such stuff as you find at hand.

[Ill.u.s.tration]

Loosen the pins by striking them on all four sides before you try to pull them up. A spade is a fine thing to use to pry out a pin that is deep in the ground, and a wooden mallet is better than an axe or hatchet to drive them in with; but, unless you have a large number of pins to drive, it will hardly pay you to get a mallet especially for this business.

Make a stout canvas bag to hold the tent-pins; and do not fold them loose with the tent, as it soils and wears out the cloth.

BEST SIZE OF TENTS.

The majority of people who go into permanent camp prefer tents considerably larger than the army wall-tent; but, unless your camp is well sheltered from the wind, you will have constant and serious troubles during every gale and thunder-storm, if you are in a large or high tent. A large tent is certainly more comfortable in fine weather; but you can make a small one sufficiently cheerful, and have a sense of security in it that you cannot feel in one larger. But, if you will have a large tent, make it of something heavier than drilling.

If you have two tents of the same height, you can connect the tops with a pole, and throw a fly, blanket, or sheet over it on pleasant days.

Do not pack away a tent when it is damp if you can possibly avoid it, as it will mildew and decay in a few days of warm weather. If you are compelled to pack it when very damp, you can prevent decay by salting it liberally inside and out.

Before you put away your tent for the season be sure that it is perfectly dry, and that the dead flies and gra.s.shoppers are swept out of the inside. You should have a stout bag to keep it in, and to prevent its being chafed and soiled when it is handled and carried. You will find a hundred good uses for the bag in camp.

FOOTNOTES:

[12] You cannot find this sort of duck in the market now, but "heavy drilling" 29-1/2 inches wide is nearly as strong, and will make a good tent.

[13] Tents made of heavy drilling were also furnished to the troops, the dimensions of which varied a trifle from those here given: they had the disadvantage of two seams instead of one.

[14] If the party is of four, or even five, a shelter-tent made of three breadths of heavy drilling will accommodate all. _Sew_ one end-piece to each half-tent, since sewing is better than b.u.t.toning, and the last is not necessary when your party will always camp together. Along the loose border of the end-piece work the b.u.t.ton-holes, and sew the corresponding b.u.t.tons upon the main tent an inch or more from the edge of the border.

Sew on facings at the corners and seams as in the army shelter, and also on the middle of the bottom of the end-pieces; and put loops of small rope or a foot or two of stout cord through all of these facings, for the tent-pins. You will then have a tent with the least amount of labor and material in it. The top edges, like those of the army shelter, are to have b.u.t.tons and b.u.t.ton-holes; the tent can then be taken apart into two pieces, each of which will weigh about two pounds and a quarter.

Nearly all of the work can be done on a sewing-machine; run two rows of st.i.tching at each seam as near the selvage as you can.

[15] Called also wedge-tent.

[16] To find the distance of the corners, multiply the width of the cloth (29-1/2 inches) by 3 (three breadths), and subtract 2-1/4 inches (or three overlappings of 3/4 inch each, as will be explained).

[17] What is known by shoemakers as "webbing" is good for this purpose, or you can double together and sew strips of sheeting or drilling.

Cod-lines and small ropes are objectionable, as they are not easily untied when in hard knots.

[18] The poles for army A-tents are seven feet six inches.

[19] This name is given to the piece of wood that tightens the guy-line.

The United States army tent has a fiddle 5-1/4 inches long, 1-3/4 wide, and 1 inch thick; the holes are 3-1/2 inches apart from centre to centre. If you make a fiddle shorter, or of thinner stock, it does not hold its grip so well. One hole should be just large enough to admit the rope, and the other a size larger so that the rope may slide through easily.

[20] Seven-ounce duck is made, but it is not much heavier than drilling, and since it is little used it is not easily found for sale. United States army wall-tents are made from a superior quality of ten-ounce duck, but they are much stouter than is necessary for summer camping.

There are also "sail-ducks," known as "No. 8," "No. 9," &c., which are very much too heavy for tents.

[21] The length of tent-poles, as has been previously stated, depends upon the size of the tent.

[22] What are known as "bolt-ends" can be bought at the hardware stores for this purpose.

CHAPTER X.

MISCELLANEOUS.--GENERAL ADVICE.